Analisis Hasil Pengukuran Hotspot pada Bay Kapasitor dengan Metode Thermovisi di Gardu Induk Bandung Utara

Penulis

  • KHAIR RIFO MASIANTO Institut Teknologi Nasional Bandung
  • Dini Fauziah Institut Teknologi Nasional Bandung

Kata Kunci:

Capacitor Bay, Hot temperature, Hotspot, Thermovision

Abstrak

ABSTRAK
Energi listrik yang diperlukan oleh masyarakat memiliki persyaratan basis yang harus terpenuhi oleh penyedia dan pemasok pusat, yaitu dapat mencukupi kebutuhan energi listrik dengan kualitas dan kontinuitas yang baik. Salah satu gangguan yang sering dialami yaitu suhu panas pada bagian sambungan merupakan berkaitan erat dengan proteksi dan keandalan sistem yang ada di switchyard. Pengukuran secara langsung dengan 5 peralatan terminal selama 5 bulan dilakukan pada saat pengecekan rutin bulanan dengan mengukur hasil thermovisi yaitu peralatan Bay Kapasitor dari suhu klem kenaikan tertinggi yaitu Terminal Reaktor arah Kapasitor dibulan September mencapai 41.7°C, dan suhu konduktor kenaikan tertinggi yaitu Terminal CT arah LA dibulan Oktober mencapai 34°C. Sehingga menentukan selisih klem-konduktor saat pemeliharaan peralatan bay kapasitor dengan titik panas tertinggi yaitu Terminal Reaktor arah Kapasitor dibulan September mencapai 11.6°C kondisi tersebut ketidaknormalan mayor, sehingga dilakukan tindakan perbaikan segera.


ABSTRACT
The electrical energy needed by the community has basic requirements that must be met by central providers and suppliers, namely being able to meet the needs of electrical energy with quality and continuity. One of the problems that are often experienced is the hot temperature at the connection. Direct measurements with 5 terminals for 5 months during routine checks by measuring the results of thermovision, namely the Bay Capacitor equipment from the highest increase in the clamping temperature, namely the Reactor Terminal in the Capacitor direction in September reaching 41.7°C, and the highest conductor temperature increasing, namely the CT Terminal in the LA direction in October reaching 41.7°C. 34°C. Thus determining the difference between clamps and conductors during maintenance of capacitor bay equipment with the highest hot point, namely the Capacitor Reactor Terminal in September reaching 11.6°C, this condition was a major abnormality, so immediate corrective action was taken.

Diterbitkan

2023-02-23