Naskah ini versi lama yang diterbitkan pada 2022-06-21. Baca versi terbaru.

Penerapan Sistem Kontrol Berbasis Arduino Pada Manual Gate Valve ½ Inchi

Penulis

  • MUHAMAD YUSUF Teknik Mesin, Institut Teknologi Nasional Bandung
  • LIMAN HARTAWAN Teknik Mesin, Institut Teknologi Nasional Bandung

Kata Kunci:

motor servo, manual gate valve, mikrokontroler arduino

Abstrak

ABSTRAK
Manual gate valve merupakan sebuah komponen untuk membuka aliran dengan cara mengangkat gerbang penutupnya. Penerapan sistem kontrol berbasis arduino pada manual gate valve ½ inchi ini yaitu memodifikasi manual gate valve menjadi control valve, menerapkan sistem kontrol berbasis arduino pada manual gate valve, menguji sistem kontrol berbasis arduino pada manual gate valve. Prinsip pada alat sistem kontrol manual gate valve yaitu Reservoir diisi dengan air hingga penuh, lalu nyalakan pompa sehingga air yang di reservoir bergerak menuju pompa dan masuk ke control valve, setelah itu control valve di buka sesuai set point. Hasil pemilihan komponen instrumentasi dan kontrol, sistem ini terdiri dari arduino uno, rotary encoder, motor servo DS04. Dalam control valve memiliki sistem kopling antara poros katup dengan poros motor servo yang terbuat dari bahan nylon dengan dimensi D1 30 mm, D2 20 mm, D3 10 mm, D4 4 mm, Tinggi 25 mm. Dimensi casing sistem gate valve adalah 120 mm x 80 mm x 0.8 mm dengan bahan plat.


ABSTRACT
The application of the arduino control system on this inch gate valve manual is to modify gate valve manual into control valve, implement the arduino based control system on the gate valve manual, testing the arduino control system on the gate valve manual. Principle on the tool of the control system manual gate valve that is reservoir are filled with water till it's full, then turn the pump on so that the water in the reservoir moves toward the pump and gets in the control valve, the valve is open afterward a set of points. The valve valve has a clutch system between a valve shaft and a servo motor shaft made of nylon material and a 30-mm dimension d1 30 mm, d2 20 mm, d3 10 mm, d4 4 mm, 25 mm high. The dimension in the gate valve system valve is 120 mm by 80 mm by 0.8 mm with the plate material.

Diterbitkan

2022-06-21

Versi